#Kaleidescope kplayer 6000 for mac
#Kaleidescope kplayer 6000 serial number
#Kaleidescope kplayer 6000 install
#Kaleidescope kplayer 6000 serial

HyperTerm or PuTTY) to 8 data bits, no parity, 1 stop bit (8N1), and no flow control. Use a straight-through cable for players and a crossover cable for servers. Then configure a serial-capable terminal emulator (e.g.

#Kaleidescope kplayer 6000 serial

If the IP address of a Kaleidescape component cannot be determined, you can reset the IP address by connecting the RS-232 port of the component to a standard DB-9 serial port of a computer with a DB-9 serial cable. Third: Connect via serial and set back to DHCP ( Kaleidescape KB article ) The output contains all network information

See this PDF: Kaleidescape-Quick-Reference-Retrieving-Diagnostic-Information First replace the disc and let rebuild the filesystem Second way: Take a serial capture ( Kaleidescape KB article )ĭon’t do this if a hard disk is amber! Requires a restart which may is dangerous if a disc already is amber/failed.

#Kaleidescope kplayer 6000 for mac

The procedure for Mac users is similar, but append “.local” to link local address, for example. Reset the settings in the Internet Protocol (TCP/IP) Properties window to the original settings previously noted. Click OK, then click Close in the LAN Properties window. In the LAN Properties window, select Internet Protocol (TCP/IP) and click Properties. In the LAN Status window, click Properties. To undo the link local address, select Start > Settings > Network Connections > LAN on the computer. The link local address is not suitable for normal operation. After the Kaleidescape System has been configured, undo the link local address.Click the Settings button for the server. In the browser interface, select the SETTINGS tab, then select Components in the second row of tab.

#Kaleidescope kplayer 6000 serial number

For example, if the server serial number is 0000 0001A2B3, then the link local address is ll-00000001A2B3. Here “ll” is two instances of the letter l.

The link local address of the server is ll- followed by the 12-character serial number of the server.

Check that the Kaleidescape server is powered on and connected to the network switch the server front panel should glow blue.

Click Close in the LAN Status window, if still open.

Click Close in the LAN Properties window.

The Internet Protocol (TCP/IP) Properties window closes.

Click Use the following IP address and type 169.254.101.101 for IP address and 255.255.0.0 for Subnet mask.

You will change these settings, and then undo the changes.

Take note of the settings in the Internet Protocol (TCP/IP) Properties window.

The Internet Protocol (TCP/IP) Properties window appears.

In the LAN Properties window, scroll down the list of items and select Internet Protocol (TCP/IP).

On the computer, select Start > Settings > Network Connections > LAN.

#Kaleidescope kplayer 6000 install

If not, install Bonjour Print Services for Windows according to the instructions at.

Check that NetBIOS name resolution is enabled.

Connect the computer by an Ethernet patch cable to the same switch as the Kaleidescape server.

(The following steps are for Windows XP.) Use a computer with a Windows operating system.Before you attempt this procedure, try the other methods described in You should understand networking in the Windows operating system to safely make the changes. In the rare case that the Kaleidescape server has an unknown static IP address and the server is on a different subnet than the computer, it is possible to access the browser interface using an alternate address, known as the link local address.įollow the procedure below to access the browser interface of the Kaleidescape server using the link local address. First and easiest: Using local link (Kaleidescape KB article )